Related posts

Feature

Individually Addressable.Dream full color Programmable LED Strip,WS2813 led, WS2811 IC Built in 5050SMD.256 brightness display and 24-bit color display. One IC controls one Led .Every led can be cut
Dual-signal wires version, signal break-point continuous transmission. If one led is damaged, the following LEDs still work well.Backup data PIN.
Wide compatibility. It is well compatible with Arduino, Adafruit NeoPixel Library, FastLED library and Raspberry Pi,K-1000C,SP105E bluetooth controller,etc.You can DIY your project with this Led strip
Easy installation. It comes with screws and clips instead of the 3M tape on the back.
Connect freely. It comes with 4-pin JST SM connectors and separated power/ground wires on both ends, which makes it easy to hook up each other and wire up for power.

Description

Parameter

Brand: BTF-LIGHTING
Light source: 5050 RGB LED
Led Qty: 30Leds/m total 150 Leds
Wave length (NM): R,650nm ; G,520nm ; B,460nm
The gray level: 256
Color: full color (24-bit )
View angle:120
Voltage: DC 5V
Power: 9W/M total 45W
Waterproof: IP67 waterproof Silicone sheathing
FPCB board color: black
Dimension: 5000*12*3mm
Life span:50000hrs

Every Pin Function

5V: Power Voltage, connect to "+5V"
DO: Control data signal output
DI: Control data signal input
BO: Backup control data signal output
BI: Backup control data signal input
GND: Data &Power Grounding

Technical Features
The control circuit and RGB chip are integrated in a 5050 components, to form an external control pixel.
The control circuit and the LED share the only power source.
Using the built-in signal reshaping circuit to achieve the signal waveform shaping, and no distortion of waveform of signal takes place.
Built-in power-on reset and brown-out reset circuits.
Port scanning frequency reaches to 2KHz/s.
Serial cascade interface. Data receiving and decoding depend on just one signal line.
Dual-signal wires version, signal break-point continuous transmission.
If the transmission distance between any two points is less than 3m, another circuit is not needed.
When the refresh rate is 30fps, cascade numbers are far more than 1024 points.
Data transmitting speed is up to 800Kbps.

Package
1x 16.4ft 150 pixels WS2813 led strip
1x4pin female connector
Power supply or controller is not included