Zooz Z-Wave Plus Wall Dimmer Switch ZEN22 (White) VER. 2.0, Works with Existing Regular 3-Way Switch

Related posts

Feature

QUICK & RELIABLE: Manual or remote on/off and dimming control from your mobile device or computer (when included to a Z-Wave gateway controller - sold separately). Reports status instantly!
DIRECT 3-WAY SOLUTION: No add-on switch needed! Works with mechanical 3-way switches as long as NEUTRAL is present. On/off only from the slave switch (dim lights from ZEN22 or your Z-Wave hub)
SMART DIMMING: Improved dimming capability for LED bulbs (scroll down for details, NOT compatible with Luminus bulbs). Remembers and restores on/off status after power failure. UL certified.
Z-WAVE PLUS: Better range and communication speed. Works with most certified Z-Wave hubs (NOT compatible with Iris).
QUICK INSTALLATION: Just tap the upper paddle 3 times while the hub is inclusion mode to add to your network. Follow wiring instructions carefully. NEUTRAL WIRE REQUIRED!

Description

    NOTE: Do NOT connect this switch to ceiling fans, motors, or home appliances. Use with lighting only.
    NEUTRAL WIRE REQUIRED

      SPECIFICATIONS:
    • Model Number: ZEN22 VER 2.0
    • Z-Wave Signal Frequency: 908.42 MHz
    • Power: 120 VAC, 60 Hz
    • Minimum Load: 15W for LED and CFL bulbs
    • Maximum Loads: 500W single, 400W 2-gang, 300W 3-gang Incandescent, 150W CFL or LED
    • Z-Wave Range: Up to 100 feet line of sight
    • Operating Temperature: 32-104 F (0-40 C)
    • Installation and Use: Indoor only


      • Will it dim my bulbs?
      You'll be able to adjust brightness levels between 10% and 100% (with full on/off capability) for the following popular dimmable LED bulbs:
    • Amazon Basic
    • BROADA
    • CMYK Edison Style
    • CREE
    • Ecosmart
    • GE
    • Halo
    • Philips
    • Sunco
    • Sylvania
    • Utilitech Recessed Dimmable LED's
    • Utilitech Dimmable LED's

      • Manual Operation:
    • Click the upper paddle to turn on the light to the last brightness level. It takes around 3 seconds for the dimmer to reach full brightness. The ramp rate is not adjustable.
    • Click the lower paddle to turn off the light (with a fade-out effect and 3-second ramp rate).
    • Press and hold the upper paddle to add more brightness. Press and hold the lower paddle to reduce brightness.
    • After power failure, the switch will automatically turn on to the last brightness level.
    • In a 3-way installation, the slave (mechanical switch) can only turn the light on or off. The slave switch will always turn the light on only to the last brightness level. Dimming is only available from the master Zooz switch and your Z-Wave software.