Related posts

Description

Pocket Photodiode Geiger Counter Kit

Experience Level: Intermediate

A DIY geiger counter that uses a PIN photodiode as a substitute for an expensive Geiger-Mueller tube. It detects alpha and beta radiation particles. The circuit is soldered onto a small protoboard and everything is placed in an aluminum enclosure. Copper tubing and a piece of aluminum foil is used to help filter out noise and RF interference. Be sure to check out what others are saying about the Pocket Photodiode Geiger Counter project build!

Required Tools:
Soldering iron and solder
Aluminum foil
Electrical tape
Drill
Step drill bit
Hand tools
Jumper wiring
3 CR1620 coin-cell batteries, or any coin-cell batteries to add up to 9V
2 pieces of 1/2" diameter x 2"L copper tubing available at Home Depot

Kit Includes:
1 Aluminum Enclosure
10 0.01uF Capacitro
1 LM358N IC
1 100uF Capacitor
10 2N7000 Transistor
10 2N3904 Transistor
10 0.100" Housing Connector
10 Crimp Connectors
1 Battery Holder
10 Red LED
1 2-Pin Male Header
1 Piezo Buzzer
1 Toggle Switch
1 Potentiometer Knob
10 0.1uF Capacitor
1 250k Potentiometer
1 0.02uF Capacitor
10 56k Resistor
10 150k Resistor
10 1.5M Resistor
10 10M Resistor
1 PIN Photodiode
10 1k Resistor
1 8-Pin IC Socket
1 Prototyping Board
1 Fliptop Box Enclosure
1 Instructions

Club Jameco Project #20255