Related posts

Feature

Suitable for E3D V5/V6 nozzle
Accuracy: 0.05mm
The LED will light when the sensor is triggered
Please make sure the temperature of the nozzle is not over 45C, or the sensor could be damaged.
Please make sure the connecting is right before leveling the bed, you might need to change the order of the cable according to different mainboard.

Description

How to use it?
1. Upload a firmware with auto bed leveling function to the mainboard.
2. Connect the sensor through the LED board to Z-min on mainboard (depending on different firmware, mostly Z-min) You might need to change the wires' order to fit different mainboard. S is for signal, + is for +5V, the last one is for GND.
3. Mount the sensor to the nozzle (without heating to 45C). Turn on the power, if the connection is right, press the sensor, the LED will light. Otherwise, please check the connection.
4. Use the function of auto bed leveling to level the bed.
5. Remove the sensor from the nozzle to start testing or printing.

Packing list:
1 * Auto leveling sensor
1 * Adapter with LED
1 * 70cm 3-pin cable
Visit this web for more details: marlinfw.org/docs/configuration/probes.html