Related posts

Feature

Safety Arming Feature: Regardless the throttle stick position, the motor will not spin after battery connected
Throttle Calibration: Throttle range can be configured to provide best throttle linearity, fully compatible with all market available transmitters
Brake Setting: brake enabled / brake disabled. Battery Type: Li-xx(Li-ion or LiPo) / Ni-xx(NiMh or NiCd)
Low Voltage Protection Mode(Cutoff Mode): Gradually reduce the output power / Cutoff the output power Low Voltage Cutoff Protection Threshold (Cutoff Threshold): low / medium / high
Full Protection Features: Low voltage cutoff protection / Over-heat protection / Throttle signal lost protection

Description

4PCS Hobbywing Pentium 30A Speed Controller for brushless motor rc airplane, heli, quadcopters + Program Card

Hobbywing 30A ESC Speed Controller

1 Specification
1.1 Output: Continuous 30A, Burst 40A up to 10 Secs.
1.2 Input Voltage: 2-4 cells lithium battery or 5-12 cells NiCd/NIMh battery.
1.3 BEC: 2A / 5V (Linear mode).
1.4 Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles Bruless motor
1.5 Size: 45mm (L) * 24mm (W) * 11mm (H)
1.6 Weight: 25 grams

Hobbywing Pentium Series ESC Program Card Hobbymate ESC
For hobbywing Pentium Series Speed Controller and Hobbymate Peak ESC Only***

With HOBBYWING's Program Card, you can easily set the programmable values of the brushless Electronic Speed Controller (ESC).
HOBBYWING's Program Card has a friendly user interface. It is as small as a business card, so you can put it in your pocket when you are on field.
Note: This program card is available f
or HOBBYWING's Fentium , Guard, Sword series ESC.
1 Specification
1.1 Size: 92mm (L) * 52mm (W) * 6mm (H).
1.2 Weight: 26g
1.3 Input Voltage: 4.8-6V (If the ESC has not a built-in BEC, you must use an additional battery pack to supply the program card)

2 Control Panel
1 Use "up/down" button to select programmable item, use "left/right" button to select options of each item; 3.2 Use "OK" button to save the settings in the ESC. 3.3 Use "LOAD DEFAULT" button to reset each item to its default setting.